-Installing

Whilst Sticker Superstores tutorial is being produced.  We have added the best tutorial on youtube as a short term alternative.  Best viewed using Firefox.

FOR NON ELECTRICAL SURFACES (car windows, trailers, motorbike etc)

Prepare a solution of soapy water and pour it into a clean spray bottle. Clean surface of dust and etc

Use the spray bottle to wet the entire substrate surface

Make sure the adhesive film is flat on the table. Pull the backing off it (not the clear application tape) at an angle of 30°. This can be a little tricky so take your time.

Wet the adhesive all over using a spray bottle

Place the sticker on the wet substrate surface. Move sticker into location

Squeegee horizontally, working from the centre outwards to the left and then the right.

Apply enough pressure to squeeze out any water trapped between the adhesive and the substrate surface.  Be very careful not to destroy your sticker by pushing to hard.

Check that no pockets of water/air have been trapped. If this is the case, squeegee from the centre to the edge in order to squeeze it out. Wipe the vinyl and the edges.

It is advisable to wait between 30 and 90 minutes before removing the application tape. It should not be left in contact with the vinyl for more than 24 hours once sticker has been applied to surface.

Pull the application tape off at a steady speed, at a cleaving angle of 0 to 30°.

After 30-90 minutes if necessary, squeegee the film again, paying particular attention to the edges.

We are not held responsible for damage whilst sticker is being prepared or fitted.

IF YOU ARE NOT CONFIDENT DOING THIS, GO TO YOUR LOCAL SIGN WRITING SHOP TO GET IT APPLIED PROFESSIONALLY

The Stickersuperstore.com.au Team.